State AP is powered on. If any of the devices in your wireless network does not support WPA, it is recommended that you choose WEP encryption. To configure and operate the AP in bridge mode, you need to be directly connected to the Ethernet port. The “Operating Mode Selection” window will appear. The AP is a 3-in-1 device: AirTies Mesh was designed to optimize wireless coverage range in the least invasive and most power efficient manner.

Uploader: Grora
Date Added: 27 February 2006
File Size: 7.40 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 44741
Price: Free* [*Free Regsitration Required]

All AirTies wireless products and the newly introduced It can stream multiple HD video channels, deal with both multicast and unicast traffic and prioritize the TV service over general traffic.

AirTies AP-301 Free Driver Download (Official)

AP added to Airtied network and coverage extended further. Preparing For Installation The installation settings of the AP must be done from a PC that is directly, not wirelessly, connected to it.

The diagram below is an example of the AP’s use as a bridge connected to a printer. In the above example, 49dBm satisfies this requirement.

Management The default password for accessing the web-based user interface of the AP is blank. AirTies will not be held responsible in such circumstances.


Airites have an account? In the window that appears, you can enter the MAC addresses of the devices that are permitted to access the AP Enter text from picture: Enter the broadcast channel number frequency in this field.

Plug and Play – pre-paired pack of devices. Monitor Wi-Fi — collect Wi-Fi history for later analysis. At the point where the wireless signal from the RT weakens, the AP will boost the signal and extend the coverage area.

AirTies AP-301 User Manual

Computers on the network connect to the AP with the strongest signal, and reach the router or the wired network through the AirTies Mesh Network. Wireless Video Operator grade video streaming capable.

Got it, continue to print. They should also have a transmit power of at least dBm. Click “Save” to complete the Repeater Settings.

A; access point will appear in the list below, titled “Access Points to Connect to”. No other device but those permitted can connect to the AP Select the wireless mode the AP will be operating in. Ergonomically designed, with a 10x10x8 cm small form factor, takes up minimum space.



If you have assigned a different SSID to your wireless network during configuration, connect to that one. The AP is a 3-in-1 device: Configuring the AP as a Repeater Therefore, the IP address of the computer should be in the airites Configuring the AP as a Repeater The screenshot below shows the RT Mesh setup screen.

You can connect the AirTies AP to a wired router through the Ethernet port to setup akrties wireless a network and enable your wireless computers to access the Internet. The diagram below is an example where the AP is being used as an access point device.

DoC for Air You can adjust the wireless data rate of the AP The AP does not do wireless broadcast in bridge mode.